Setting Kitchen Printers

Setting Kitchen Printers

  1. In Vectron, flagging items for kitchen print is on a per department basis rather than per product.

  1. Turn off the Vectron terminal by holding down the power button toggle switch. Switch the terminal back on, keep tapping the screen whilst the boot process is taking place. This will bring the device into the program mode as seen below.



















  1. Press "Program Mode".


  1. Go into "PLUs etc > Departments".


  1. While in the departments screen tap the 3 dots beside printers.


  1. Select the printers you want to enable by tapping on printer 1, 2, 3 etc.
























    • Related Articles

    • ICRTouch - Kitchen printer stopped working

      Kitchen printers can stop printing for a number of reasons. The most common are listed below: Loose Connections - Are all cables pushed in fully to the printer itself, the till and to any network ports in the walls? Out of paper/jammed - Please check ...

    • Vectron - Program Printer

      If Print Data is set under Net/Comm parameters then the till selected will handle all of the printing information. Print Data allows a till to send all of its print jobs to the till set in the parameter. e.g Print Data = 3, the till will send its ...

    • Vectron - Program Departments

      Number Reference for linking to PLUs and other areas Name Only seen through reporting tools. Keep descriptive Icon Unused Main group 1 Main Group report is handy for reporting specific departments. E.g Open food, tobacco, deposits. Set the number to ...

    • ICR Touch - Text message status button cutting off

      Question: I have noticed recently an issue with the Text Message status key. The print out in the kitchen appears to cut off at around 20 characters. Is there a way to adjust this so it overflows to the next line? The cut off messages are leading to ...

    • ICR Touch - Running a single report for whole site vs a report per till

      Question: I was wondering how to change the reporting setting so that a client can run a report on an ECR that Z reads all the ECRs in the network. Currently the system is set up to report the tills individually but I would like to give them the ...