Till boot issue fix - Error Abort 61 (after Dump flashing)

Till boot issue fix - Error Abort 61 (after Dump flashing)

Switch machine off
Put your thumb halfway up screen at left side about 1 inch in from edge.
Hold it there while you switch it on
Remove it immediately when machine bleeps takes about 30secs to 1 minute
Then when grid is on screen press
Del inv data button.
Should load ok now.
This can happen when you are loading to a different flash.

    • Related Articles

    • Customer signed off - Error 62

      Press 1 then Operator no. will fix this issue.

    • Vectron - Error Fix Solutions

      Type in 999 Then mode Go to intit/delete Then hold buffers Then delete then yes Then escape.

    • Getting Your Windows 10 Till Back Online

      Getting Your Windows 10 Till Back Online A step-by-step guide for after you change your broadband or router Your till was set up with a fixed network address that matched your old broadband router. When you change provider, the new router normally ...

    • ICRTouch - Till not turning on

      Please make sure there are no loose connections to the till & sockets, and that the socket has been turned on at the relevant plug at the wall and extension lead if relevant. If you have other tills on site, Please test one of the power supply bricks ...

    • Vectron - To operate phone order on till

      TO OPERATE PHONE ORDER ON TILL: SIGN ON AS NORMAL PRESS PHONE ORDER/ STORE BUTTON PRESS A GREEN RECTANGLE BUTTON ON GRID PRESS ORDER NAME BUTTON TYPE IN CUSTOMERS NAME THEN PRESS RED TICK AT TOP OF SCREEN ENTER ORDER IN USUAL MANNER THEN PRESS PHONE ...